The ring die industry is facing the dilemma of increasing revenue without increasing profits

The ring die industry is facing the dilemma of increasing revenue without increasing profits. Our company specializes in the production of intelligent touch screens and injection molding machines with 560 minute permanent magnets. The steps are as follows: the shaft end is a "two-layer mold" ring mold, the pressure wheel assembly is 360 mm, and the structure is complete; The "pressure wheel" of the leftover material is refined from high alloy wear-resistant materials, which is sturdy and has a long service life; The "pressure wheel" of the leftover material is made of high-quality alloy steel material, which is sturdy and has a long service life; And it has filled the gap in vertical feeding of national environmental mold granulation, reaching the international advanced level.

The "rice milling machine" produced by the company has a novel, compact, safe, low noise, and low fault performance, and is widely used in enterprises such as wood bran fuel plants, compound fertilizer plants, and investment power plants.

Introduction to Sawdust Granulator The product has absorbed advanced foreign production technology and manufactured products that are more suitable for China's national conditions.

Sawdust particle machines have high commercial value and are currently the mainstream of the domestic economy. However, our country's sawdust particle machine products cannot meet your needs, so we must express our gratitude to you!

The sawdust granulator mainly uses wood processing particles, wood chips, rice husks, waste cloth and other biomass as raw materials. Through pretreatment and processing, it can be solidified into high-density Pellet fuel, which is an ideal fuel to replace kerosene.

There are two types of sawdust particle machines: flat mold and ring mold, which have new energy sources in the industry, which can save energy and reduce emissions, and have good economic and social benefits. It is a clean and renewable energy source.

We will heat apply sawdust, such as wood chips, rice husks, cotton stalks, cottonseed husks, weeds, and various crop straw, household waste, waste tires, etc.

Sawdust pelletizer The sawdust pelletizer is installed on the cooler and is suitable for pressing materials that are difficult to bond and shape, such as rice husks, Sunflower seed shells, peanut shells and other melon shells; Various wood scraps such as branches, trunks, bark, etc; Various crop straw; Various chemical raw materials such as rubber, cement, ash, etc. Applied in feed factories, wood processing factories, fuel factories, fertilizer factories, chemical factories, etc., it is the most ideal compression and densification molding equipment with low investment, fast efficiency, and no risk.

Suitable for woodworking, fuel plants, fertilizer plants, chemical plants, etc., it is the most ideal compression densification molding equipment with low investment, fast efficiency, and no risk.

The main shaft bearing of the particle machine adopts an alloy structural steel material hoop type, with a tight ring mold milling lining plate, high strength, and long service life.

The lubrication system for the pressure roller of the particle machine can lubricate semi wet materials, the locking device for the live phase, and the safety pin protection device for feeding work.

The pellet machine mold adopts a pair of roller connected structure, with a low speed iron removal device for sorting and loading and unloading work.