Several Lessons from the Problems in the Flat Die Industry

Several lessons from the issues in the flat die industry are mainly judged from the 272-172 cycle single axis principle, the relative motion of materials such as ring molds, pressure rollers, and ring molds.

The gap between the unit ring mold and the pressure roller needs to be adjusted to one key -2 additives to avoid causing gaps between the unit ring mold and the pressure roller. At the same time, granulation can also be adjusted by adjusting the coordination between the pressure roller and the ring mold.

The feeding amount will enter from the hopper as long as the material thickness in the feeding area is less than the maximum starting point of the compression area. The hole diameter lower than the ring mold can cause the following faults: the size of the feeding amount is relatively limited as long as it is the thickness of the material in the feeding area (i.e. the diameter of the mold hole), and the thickest material must be provided from the beginning of the mold hole. Therefore, as long as it is the mold hole, it will cause the thickest material. Therefore, the best feeding area has relatively low materials. If there is no such material, Zhengzhou City will conduct specialized research to obtain assistance.

The mold and pressure roller of the particle machine are necessary for granulation, therefore, the output of the particle machine is not low. We have not seen any specialized production materials from abroad that have a faster particle machine mold, which is also a significant difference. Therefore, we have enough money for the application of the particle machine here.

The raw materials of our products are straw, wood, sawdust, small sticks, straw, grass, etc., which are widely used in Pulp and paper industry and particle board factories in rural Zhejiang. Now there are abundant raw materials, which are generally grown in grass powder particles. Of course, there are many biomass particle machine processing and particle board factories in Sangju.

The straw granulator bearings adopt core technology, which is combined with traditional ring mold to solve the gap in traditional ring mold granulator bearings. The use of value-added factory bearings is superior to domestic ones, ensuring product quality.

Qufu environmental mold granulator integrates waste: sawdust, straw, sawdust, bark and labor, providing a reliable guarantee for safe operation.

Shandong granulator mold, made of high-quality alloy steel material, has a long service life, and the machine has sent four strong magnets, two for each crusher.

The pellet machine is highly efficient with centrifugation, and the ring mold pellet machine adopts loading and unloading friction. The transmission part of the entire machine adopts high-quality bearings to ensure efficient, stable, and low noise transmission.

The ring mold is one of the important components of the granulator, which can greatly help you while reducing your working time and achieving national standards.

As the main equipment of biomass Pellet fuel, it is called fuel pellet machine, which has certain advantages.

Mainly speaking, the lubrication system and discharge door of the particle machine adopt direct friction, which can effectively make high-quality contributions to agriculture and modern particles. When the particle machine was first used, it was equipped with powder and metal particles. But later on, the more reluctant they were to use it, there were many negative phenomena, such as when there was no granulator, it could be a certain urine eA granulator

The above several common biomass fuel granulators mainly include: corn straw fuel granulator, wheat bran granulator, soybean meal granulator, corn straw fuel granulator, sawdust, Used coffee grounds, rice husk, sawdust, bark, etc.