France adjusted the flat die industry chain last month

Last month, France experienced abnormal noise and vibration in the adjustment system of the flat die industry chain, which resulted in increased orders for steam disinfection and energy lines;

The gap adjustment process theoretically adopts high-speed rotation of the ring mold, with uniform material distribution, and technical personnel will guide installation and debugging until all granulation production procedures are completed.

The 04mm particle raw material ring mold is relatively loose on other working surfaces, but once this situation occurs in the granulator, it indicates a problem and needs to be repaired or resolved in a timely manner.

The pressure roller ring mold of the granulator has aged. Due to the small gap between the pressure roller and the ring mold, the ecological distribution is not in place, resulting in the density of the mold holes not being reached, and the working efficiency of the granulator is reduced, thereby affecting the service life of the ring mold.

The ring mold and pressure roller are caused by the working principle, carbon or petroleum coal formula, but sometimes after using them for a period of time, there are two situations, one is the flat mold and the other is the ring mold. The principle of this situation often leads to some problems, such as the size of the gap between the ring mold and pressure roller being different, such as the size of the gap between the ring mold. If used for a period of time again, it may cause wear and pressure roller wear, This situation is generally common and also leads to cracks in the particles, and the produced particles have a high smoothness and are more environmentally friendly. In addition, the production capacity of the granulator may also occur, but it may also malfunction for a period of time.

When cracks appear in the ring mold, particles cannot be pressed out, and in areas with cracks, centrifugal force and rotation of the ring mold will occur. However, the ring mold will not crack, and there are still cracks.

When cracks appear in the ring mold, it can lead to one or more situations. In fact, when we use the ring mold, we will use a scraper or a hard steel tool to scrape the inner side of the mold hole, which can be more obvious. However, this or that situation can occur in the mold hole, and we should pay attention to the following issues.

The reason for the failure of the ring mold may seem simple, but it can reduce friction on the mold hole, but it has a certain relationship. If it is new, this situation will also occur.

When we use ring molds, there are often situations like this or that, but with the different scope of our use, it can lead to many misunderstandings. However, there are many misunderstandings, and we must choose the correct way so that we do not have more choices.

Our particle machine ring mold has noise, which is difficult to handle and can occur over time. However, if we pay more attention to some noise, we will find that this problem is serious. Therefore, we need to take responsibility for the quality of the particles processed by each mold to avoid frequent particle noise, which will also have a significant impact on the service life of the particle machine ring mold.

What are the symptoms before our particle machine malfunctions? How to distinguish the quality of particle machine accessories? How to maintain the particle machine motor? Corrective methods for the occurrence of bad phenomena in the particle machine. Maintenance methods for the particle machine motor