The secret I have summarized after studying multiple flat die products

After studying multiple flat die products, the secrets I have summarized should not exceed those of civil environmental die equipment in various countries in China.

● m Biomass Pellet fuel generally has a certain impact on grass powder, but with the widespread use of grass powder particles, the widespread use of raw materials, and the continuous accumulation of content, the output of biomass Pellet fuel is rising, and has a significant 1/12, accounting for about the size of the country.

Biomass particles are processed by using pressure rollers and ring molds under normal temperature conditions to form and compact crushed biomass straw, forestry waste, and other raw materials in a cold state. The density of raw materials is generally 01-013t/m3, and the particle density after molding is 11-13t/m3, which is convenient for storage and transportation and greatly improves the combustion performance of biomass.

Which company is good for biomass particles? The advantages of stainless steel ring molds are: imported high-precision bearings and; The ring mold and pressure roller adopt high hardness technology, and each ring mold production process produces particles with high hardness. The hardness of the particles produced is relatively high, and the designed parts are relatively low. However, for producers, their hardness is incomparable. According to our series of equipment produced by domestic and foreign processing processes, in subsequent production and construction, it will greatly enhance the production cost of biomass.

The thickness of the ring mold (T): the comprehensive motor capacity (T) is the lowest; And the linear velocity of the ring mold aperture: the inner diameter of the ring mold D=18.

Many users may ask about the thickness of the ring mold and the center of the ring mold when using it. Relatively speaking, the diameter of the drum and the inner diameter of the ring mold D=18.

The ring mold is one of the main components of the granulator, which greatly affects the use of the ring mold. When designing similar structures, we have learned that the structure of the ring mold granulator mainly includes straight holes and stepped holes. The general line of this granulator can effectively suppress particles, while the straight hole hole requires increasing various aperture holes and stepped holes to facilitate the use of the pressure roller and ring mold.

The deflection scraper is worn out, which is usually between 3-5mm. If it is adjusted properly, the phenomenon of deflection scraper will occur, which is generally not the case.

Use the correct mold hole structure and determine the appropriate scraper angle based on different formulas and process methods.

For conditional ring molds, severe wear of the scraper can lead to expansion of the mold hole and blockage of the mold hole.

The gap between the ring mold is too small, and the mold hole is too large. It is recommended to rent a pressure roller.

For ring molds that are prone to wear and tear, this situation usually involves the appearance of many particles on the surface. However, this situation is relatively rare, and the surface of particles may produce mold holes of varying lengths, all of which have certain changes in size. It is necessary to replace them in a timely manner.

The gap between the ring mold is too small. If you are a granulator in the same new mold industry, you can see many of these problems, and there are many people asking about the eccentric block of the ring mold. After greeting, there are also many people who usually use the same model. When greeting, many people usually use the same model. To address the main reasons for these granulators, such as raw materials, energy consumption, formula granulation, and ring mold compression ratio.