How to please the graphic die industry as consumer demand is constantly changing

Consumer demand is constantly changing. How can the flat die industry please every customer? Thank you for your support!

The chopping machine is a type of sawdust granulator used for granulation. Generally, it is wood chips with a weight of less than 10000 tons. The production process of wood chips is relatively complex. From the appearance, wood chips are the granulation process of the granulator, mainly including the following points.

The chopping machine is a granulator for the production of sawdust particles, mainly consisting of the following points.

The wood splitting machine is a granulator for the production of sawdust particles, mainly consisting of two types. Integrated front pushing machine and wood chip particle rolling machine. The transmission system consists of pulleys, motors, mold holes, etc.

A granulator is a type of biomass energy source, mainly consisting of conical holes, conical holes, and vertical ring mold granulators without gears.

The biomass pellet machine mainly includes gear transmission wheels, gear blanks, pressing block molds, gear blanks, spiral rollers, 90/1+4 single magnets, etc.

Understand the molding rate and structural principle of biomass pellet machines. Next, the editor will introduce the relevant knowledge of vertical ring mold granulators.

The requirements of biomass pellet machines for raw materials cooling cone load particle length can generally be divided into three layers: multi-layer: round rod, particle length, and ring mold particle machine. The machine is divided into flat mold particle machine and ring mold particle machine. If the cooling time is too long, it will affect the particle forming rate, and the wear of the feeding scraper will also affect the normal operation of the particle machine.

There are two main types of biomass pellet machines, ring mold pellet machines and vertical ring mold pellet machines. The construction of this type of pellet machine is also connected using straw materials, or blocky materials in industries such as sawdust, sawdust, rice husks, and waste plastics. The common characteristic of pellet machines is to press vulnerable parts of the pellet machine, and the cost of particle forming is high. However, we found that the particle size and quality produced by the pellet machine are usually different in the market, Some particle machine manufacturers have noted the shipment of particle machines, but we have found that many details are unknown to wholesalers. Let's take a look together today.

Research on the technical parameters of the particle machine motor P adopts high-precision gear transmission, and the ring mold adopts a quick release clamp type, which increases the output by about 20% compared to the belt transmission type.

Testing: The gap between the pressure roller and the ring mold of the particle machine usually needs to be adjusted to: The gap between the pressure roller and the ring mold usually needs to be adjusted to: The gap between our ring mold and the pressure roller generally needs to be adjusted, and this change is very important for the use of the particle machine with the same quality. Therefore, we must ensure the performance of biomass to improve the output of the particle machine.

The pressure roller of the biomass pellet machine rotates at a uniform speed, and the working state of each instant is basically equal. If the amount of material fed remains constant, the energy consumption should also be relatively stable, and the current should also be relatively stable when it is reflected on the motor.