The roller shell industry is facing a major crisis

When encountering a major crisis in the roller shell industry, there will be many vulnerable parts, some of which still have equipment advantages and are prone to small particle machine failures. However, if this is the case, it will be very different, especially when there is a risk of large door opening. Therefore, we must choose a good cleaning method.

Shell type large volume belt conveyors are rare cases where the equipment surface area increases due to the increase in industry area. Large professors at the Longzhou Expo encounter many large volume, such as 1, 3, 4, 5, 4, and the gap between the ring mold and the transmission wheel. Whether the gap between them is considered, there may be many abnormal phenomena. However, if the gap between them is not as large as before, their work will not be like this, Instead, many cracks will appear.

The gap between the ring mold and the drive wheel is the driving force for granulation, which is relatively high in pressure compared to the belt conveyor and suitable for this industry, but generally there are no defects. The general lifespan of the ring mold is over 3000 hours, and some granulation lifespans may have defects, which is very obvious.

The ring mold is the main component of granulation, which greatly affects the service life of the ring mold and pressure roller, resulting in the ring mold being uninterrupted throughout its life. Therefore, we need to inspect the previously used components and regularly check whether the ring mold and pressure roller are damaged.

There are three types of pellet feed pressing machines, with stable ring mold quality, high output, low power consumption, simple operation, and convenient movement.

The gap between the ring mold and the pressure roller is generally 01mm-03mm, which makes it easy to replace the size of the ring mold and vulnerable parts. However, if the gap is too large, the particle machine will suffer losses. Therefore, it is necessary to filter various advantages so that there is no obvious damage.

For molds that have been in use for a long time, it is necessary to ensure smooth operation, especially during operation, to ensure that the aperture is adjusted in time, so as not to have any internal defects.

The gap between the ring mold particle machines is generally 01-03mm, which will not damage the mold, but it will also not damage the mold. Therefore, after using it for a period of time, it will be found that the more leakage, the more severe it becomes, and the service life of the particle machine will also increase.

I believe everyone has their own usage methods for sawdust particle machines, but we often encounter the problem that carbon slag particle machines are not eternal. In order to avoid machine blockage, the quality of the produced particles will also be affected. Therefore, we suggest that after using them for a period of time, they can play a role in lifting. In this case, this situation is generally not caused because we pay attention to the maintenance of the sawdust particle machine every time we stop the machine, which also avoids manual wear and tear.

The maintenance method of straw pellet machine is how to improve the output of the sawdust pellet machine through the "operation" of the environmental mold pellet machine. The straw pellet machine is mainly one of the models and also has certain requirements. In general, the ring mold life of the ring mold particle machine is 1000 hours, and the minimum diameter is 220 seconds.