Research Report on the ring die Industry, Looking at How Emerging Brands Break the Circle

Research report on the ring die industry, looking at how cutting-edge brands break the circle, produce materials, and output; At the same time, some buyers are interested in this and are interested in providing good particle performance.

Twin screw extruders are used for sheet metal and utilization in the Huagan fertilizer industry. The equipment has technical parameters such as round bar, square, length diameter ratio, spiral, etc. It is a secondary granulation Show house that has no pollution to the environment and is easy to cause materials other than dust. It is suitable for all kinds of wooden materials, such as rice husks, Sunflower seed shells, peanut shells and other melon shells; Various wood scraps such as branches, tree stems, bark, etc; Various crop straw; Various chemical raw materials such as rubber, cement, ash, etc. Applied in feed factories, wood processing factories, fuel factories, fertilizer factories, chemical factories, etc., it is a compression dense forming equipment with low investment, fast efficiency, and no risk.

Powdered feed is mixed into the granulator for granulation, and is symmetrically placed into the granulator to start granulation. The produced feed particles have high hardness, smooth surface, and mature inside, which can improve the digestion and absorption of nutrients.

The particles have axial or radial cracks, and the pulverization rate is high, resulting in low yield. The reason for this phenomenon can be that the tempering temperature cannot be reached, and the material maturity is high, which can improve the digestion and absorption of nutrients and also help improve the reproductive ability of granulation.

The surface of the particles is not very smooth and the pulverization rate is high, which may be due to the small compression ratio of the ring mold. Therefore, the compression hole should be increased for ring mold compression.

When the particle moisture content is high, the production yield is low and there is often a blockage phenomenon. The pressure reducing valve can be adjusted to ensure that the steam pressure entering the conditioner is 01-04MPa, and the drain valve can play a drainage role. It is also possible to increase the tempering temperature accordingly, as an increase in temperature is beneficial for the improvement of material maturity. Generally, for every 11 ° C increase in temperature, the moisture content of the material increases by about 1%.

Ruiqi Machinery promises to adhere to the use of high-quality steel and undergo multiple processing processes to provide customers with high-quality ring molds and rollers, and promises to equip all equipment with Siemens motors and SKF bearings.