Several tips for selecting roller shell products

We will encounter many technical problems in selecting roller shell products through our practical operation. If you have any questions, you can go through.

The feeding port is an important outlet for the production of pelletizers, and anything can be called a pellet feed machine. However, our ring mold is a key challenge for pelletizers. For the use of various types of feeding machines, as long as it is determined by our needs, our pellet machine molds are of high quality, so our feeding speed must be fast and the quality must be improved. Therefore, we must be serious and responsible for the finished products fed. After the mold is compressed, the powdered feed is compressed into particles, and a series of procedures such as these powders need to be repeatedly flipped, A regular investment channel is formed between the mold holes related to the precision feed Boolean, and these feed particles can be replaced.

Stirring pellet machine (also known as pellet feed machine or pellet feed forming machine) belongs to the equipment of feed granulation. It is a feed processing machine that uses corn, soybean meal, straw, straw, rice husk, and other raw materials as raw materials, and directly presses them into particles after crushing the raw materials.

Straw particles are made of corn stalk, wheat straw, rice straw, peanut shell, corncob, cotton stalk, soybean stalk, weeds, branches, leaves, sawdust, bark and other solid wastes of crops as raw materials, which are crushed, pressurized, densified, and shaped into small stick shaped solid Pellet fuel.

Biomass Pellet fuel is extruded from sawdust, straw and other raw materials by pressing rollers and ring dies at room temperature. The density of raw materials is generally around 06-08, and the density of formed particles is above 11, making it very convenient for transportation and storage.

There are axial or radial cracks on the surface of the particles pressed out by the biomass granulator, and the pulverization rate is high. However, if this situation occurs, the fibrous cracks and pulverization rate of the biomass granulator will be different. The surface of the particles pressed out by the biomass granulator has obstacles and cracks, so what we need to do is to squeeze them to make the surface of the extruded particles different. To increase visibility, our company will recommend using a 560 plasticizing machine that meets the scene.

The surface of the particles pressed out of the treasure shell is smooth and beautiful, and the internal personnel use the SY support principle for feeding. One arm is used to ensure the formula, or to replace or replace it. The surface of the particles pressed out of the treasure shell is smooth and can only be completed by axial installation.

The length of the particles pressed out of the treasure shell is relatively uniform, but it often loosens at the main shaft and connections, especially when the gap between the pressure roller and the ring mold is relatively large. Therefore, when the particles leave the ring mold, this or that situation will occur. If it is found to be too long or too small, it will be required to replace the treasure shell and press it out.

The above is the lubrication function of the bearing of the sawdust particle machine, but there are many reasons for this problem. If it exists for a long time, it must be dealt with in order to greatly improve work efficiency. This can create a large gap between the particles and the pressure rod, and then quickly use the pressure rod and the ring mold as fuel in the warehouse, or work in biomass power plants.