The roller shell industry has launched a new decade of strategic layout

The roller shell industry has launched a new decade of strategic layout, giving you how to choose. Thank you for your unreasonable transmission system and providing us with good safety assurance.

● Gearbox after-sales service: We will contact you as soon as possible to provide you with high-quality after-sales service.

Compared to: 15 years production capacity: 95%.

● Service life of the ring mold and pressure roller: When the speed of the ring mold is too low, the pressure roller must be replaced to ensure the high efficiency, high efficiency, high-quality, low noise, and low fault performance of the ring mold.

When the working area of the ring mold is 6mm in diameter, the ring mold particle machine should be scrapped.

The ring mold must be stored in a dry and clean place. If stored in a damp place, it will cause mold hole corrosion and reduce the lifespan of the ring mold.

The ratio of the ring mold refers to the compression ratio, which is the heart of the ring mold, and the diameter of the ring mold is arranged according to different components.

The connection between the diameter of the ring mold hole and the ring mold is very important. The ratio of the roughness of the inner wall of the ring mold to the ratio of times is lower than the granulation cost. This compression ratio is related to the strength of the ring mold, which can profit the ring mold manufacturer and also contribute to granulation molding.

After using the ring mold for a period of time, it is necessary to check if there are any local protrusions on the inner surface of the ring mold. If this phenomenon occurs, a polishing machine should be used to remove the protrusions to ensure the yield of the ring mold and the service life of the pressure roller.

In addition, it is also possible to adjust the use of the ring mold for a period of time to check the overall wear and tear of the ring mold and the quality of granulation. Due to prolonged operation of the granulation equipment, the ring mold aperture ratio is large, which has a significant impact on production.

In addition, the particle machine can also lubricate the bearings, which usually occurs after a new bearing is used for a period of time, causing the temperature of the ring mold to be too high. The pressure roller shell needs to be replaced in a timely manner, and can ferment and grow in the future. Generally, the lubrication life of the ring mold particle machine is about 11-13 years.

The above is all about particle mechanism particles. I hope there is no difference in the production of powder, sulfur dioxide, pentaoxide, protein, or similar films. However, these particle machine manufacturers have provided sufficient nutritional protection for the long-term use of the particle machine, and I hope it can be helpful to everyone.

The maintenance method for the particle unit is the dismantling method for the circular mold particle machine. The inspection items for the wood chip particle machine before installation are the main characteristics of the particle unit. How to improve the output of the wood chip particle machine.