The list of raw materials for ring die needs to include the following content

The list of raw materials for ring die needs to include the following content.

The list of environmental molds can work for over an hour, such as 100 hours, but they work for a long time within 15 hours, achieving the goal of productivity.

The list of ring molds lasts for over an hour, and the length of the cutting blades of the particle machine can be adjusted to ensure the output and service efficiency of the particle machine.

The list of environmental molds lasts for over an hour, which can be reduced or shorter than other tasks. For example, if one unit can be sold in production, but it needs to be done continuously when it needs to work, so it needs to make greater contributions to the work. When the particle machine is about to be unloaded, it must be cleaned or the residual heat used in the sun should be less than or included in the electricity bill.

The filter screen of the ring mold particle machine is used to fix screws and is always free of charge. However, many people have caused a lot of damage, such as some who have caused a lot of damage, but one thing is that they have made a lot of damage. This indicates that if they encounter rentable situations, they can filter through the entire equipment to prevent sudden tool overload and machine blockage.

The filter screen of the ring mold particle machine is used for extrusion molding, and the ring mold particle machine can extrude materials and prevent the compressed materials from being squeezed into the mold during particle extrusion to form physical particles. Therefore, the fragile particle machine of the wood chip particle machine usually needs to pass through an iron removal device to avoid being generated or extruded due to intense pressure and compression during particle extrusion, and then dried and rolled into the mold, And significant wear and damage occur.

The mold of the sawdust particle machine requires professional technology to solve the pressing problems of the sawdust particle machine. Let's analyze the granulation requirements of the sawdust particle machine together: the pressure roller of the sawdust particle machine needs to be matched with the mold, because the mold pressure is too high, and each mold adds a certain amount of water from the mold to make the particles. This requirement requires special attention to the characteristics.

What are the types of straw granulators? Don't tell others. Of course, there are these issues. There are significant differences between straw granulators and sawdust granulators. Based on the above results and the problems with straw granulators, the coordination between straw granulators and sawdust granulators is also very important.

The raw materials for making wood chips must be under moisture control. There are various materials used to produce sawdust particles, such as pine and fir, sawdust, eucalyptus, fruit wood, etc. When making sawdust particles, it is necessary to pay attention to winter drying or water furnace control. What is the fermentation situation of the raw materials in the straw pellet machine, the reasons for the fermentation of the raw materials in the straw pellet machine, and the solutions.

The raw materials used for making straw granules using straw pellet machines are different, and many friends want to know if there is a straw pellet machine inside. Today, we will make a surprise!

The main transmission of the straw granulator adopts high-precision gear transmission, and the ring mold adopts a quick release clamp type, which improves the efficiency by about 20% compared to the belt transmission type.